Posted on Leave a comment

360° Video From Canada

Julien Brault-Chénier at LEOFILMS.CA sent us a link to the following great video taken by using our MewPro + Bastet system. Thanks!!


youtubeiconiOS: Open this video in YouTube app

Note 1. Please watch the clip in 4K setting and use the navigation wheel at the top left corner. Currently 4K 360-degree viewing is possible in Chrome, Edge or Firefox.
Note 2. If you are viewing this on an iOS device please install and launch the YouTube app. Then move the smartphone/tablet around to get its display revealing the scene.

Posted on Leave a comment

Extra Long Take Bug Fixed

A bug prevents long takes more than one hour and 22 minutes or so in several video modes fixed.

As of today modified modes in the newest MewPro Iliad software version 1.3.7 1.3.8 for Hero 4 are

  • 4k at 12.5fps (Hero 4 Silver only)
  • 2.7k at 48fps, 30fps
  • 2.7k 4:3 at 30fps

If you don’t shoot any long continuous takes more than an hour without a pause then updating your Iliad or Bastet is NOT NECESSARY.

Posted on Leave a comment

360° Videos at Japanese Cat Island

We have uploaded three 360-degree videos shot using seven GoPro cameras and MewPros.

Note 1. Please watch these clips in 4K settings and use the navigation wheel at the top left corner. Currently 4K 360-degree viewing is possible in Chrome, Edge or Firefox.
Note 2. If you are viewing them on an iOS device please install and launch the YouTube app. Then move the smartphone/tablet around to get its display revealing the scene.


Videos by seven GoPro Hero 4 Black + MewPro 2 with Bastet in 4K 30fps, Wide.

Video 1.

youtubeiconiOS: Open this video in YouTube app

Video 2.

youtubeiconiOS: Open this video in YouTube app


Video by seven GoPro Hero 3+ Black + MewPro 2 with Bastet in 2.7K 30fps, Wide

Video 3.

youtubeiconiOS: Open this video in YouTube app


These footages were taken using our original “Mani Wheel” rig with a modification to accommodate an additional camera pointing the zenith.

Posted on Leave a comment

How To Update Bastet Firmware

The way to update MewPro Bastet’s firmware is shown in this post.

We designed MewPro Bastet to be easily updated in the same way as the MewPro 2 board: To do so should require only the following.

  • Arduino IDE software
  • Sparkfun FTDI breakout (3.3V) hardware

However, since the current Arduino IDE doesn’t have supported Bastet’s microcontroller ATmega328PB yet, a rather complicated preparation is required.

The detailed instruction is here.

Once the IDE is ready in your PC then the actual updating can be done in the same way as what you usually do with your MewPro 2 boards.