Posted on Leave a comment

Candy Plastic Cartridge Reuse As A GoPro BacPac

MewPro PCB is sold without casing. We describe here how to make an attractive enclosure from “Frisk” by yourself.

Parts List

Frisk breath mint candies in plastic cartridge
This is sold at any convenience stores found across Japan. Unfortunately, Frisk packages in other countries are different from ones in Japan, so you might want to import them from Japan.
MewPro w/ SMD parts and Herobus connector (soldered)
In order for MewPro PCB to fit in Frisk, Arduino Pro Mini must be soldered by yourself.
Arduino Pro Mini 328 3.3V 8MHz
Genuine Pro Mini or any clone will do.
Wires and solders
and some skills…

The essential part is the Frisk plastic casing. Its depth is 10.5mm and this is almost the same as GoPro BacPac’s 10.0mm!

Left: MewPro w/ SMD parts and Herobus connector (soldered); Right: Frisk case sold in Japan
Left: MewPro w/ SMD parts and Herobus connector (soldered); Right: Frisk casing sold in Japan

Instruction

Cut the MewPro PCB a bit. Take care not to cut any conductive traces!
frisk2
Solder the Arduino Pro Mini board to the reverse side of the MewPro board.
frisk5
Cut Frisk.
frisk6
Voilà! MewPro is now inside of Frisk. Its size can be compared to bacpacs of Dual Hero System.
frisk3
frisk4

Note: If you want to make the above DIY Frisk casing we can ship Frisk from Japan. Please contact us if you need. 🙂